James D. Miller 
The Dewalt 779 and 780 miter saws are very similar tools. Both are designed for making precise cuts in wood, metal, or plastic. The main difference between the two models is that the 779 has a laser guide, while the 780 does not. Other than that, they both have the same power and capabilities. There …
To tension a scroll saw blade, first make sure the blade is properly installed in the machine. Next, tighten the set screws on the top and bottom of the blade so that they are snug but not too tight. Finally, use the adjustment knob to tension the blade until it is tight enough to cut …
Cut a piece of wood that is the same thickness as the main piece of wood. Cut the design into the thin piece of wood. Glue the thin piece of wood onto the main piece of wood. Decide on the design for your wood inlay You can either freehand a design or use a stencil …
There are a few ways to rip wood without a table saw. One way is to use a handheld circular saw. Another way is to use a hand held jigsaw. Measure the wood you need to rip and mark it with a pencil Place the wood on a stable surface, such as a workbench or …
The chain saw blade smokes because the oil and gas mix is too rich. This causes the engine to run hotter than normal and the exhaust fumes to be heavier than normal. The mixture of oil and gas also makes the chainsaw blade smoke more when it cuts through wood. If you’ve ever used a …
There are a few key differences between miter saws and Skill saws. Miter saws are designed specifically for making precise, clean cuts at angles, while Skill saws can be used for a variety of purposes and make less precise cuts. Miter saws typically have smaller blades than Skill saws, which makes them better suited for …
Bosch and Dewalt are two of the most popular brands when it comes to miter saws. Both brands offer a variety of models to choose from, so it can be tough to decide which one is right for you. Here’s a quick comparison of the two brands to help you make a decision. Both Bosch …
Angle cuts can be made on a table saw by tilting the blade to the desired angle and making the cut. The most important thing to remember when making an angled cut is to use a push stick or other device to keep your hands clear of the blade. Table saws are one of the …
To adjust the table saw, first loosen the clamping knob on the front of the saw. Then, using ahex key, turn the adjustment screws on either side of the blade to raise or lowerthe blade. To fine-tune the adjustment, use the bevel angle adjustment knob to setthe blade at a precise angle. Finally, retighten the …
Installing a chain saw blade is a relatively easy process. First, make sure that the saw is off and the blade is not moving. Next, use a wrench to loosen the bolts that hold the old blade in place. Once the bolts are loose, remove the old blade and discard it safely. To install the …
A panel cutting jig is a great way to get perfectly square cuts on large panels when using a table saw. To make one, start by attaching a stop block to the end of your workbench or table saw fence. Then, use a piece of scrap wood to create a support for the stop block …
The main reason to run high octane gas in a chainsaw is to prevent pre-ignition. Pre-ignition can occur when the air/fuel mixture in the cylinder is too hot and ignites prematurely. This can cause serious damage to the engine. High octane gas burns cooler than regular gas, which helps prevent pre-ignition. If you’re a professional …